Soldering stainless steel with tin
Are you interested in soldering stainless steel with tin from the vendor — company Electrocentury-steel? Here you will find only reliable information on this issue
Buy in the range of solders based on tin, which is suitable for soldering stainless steel, offers at producer prices company Electrocentury-steel. Supplier ensures prompt delivery of products to the address specified by the consumer.
Features soldering stainless steel with tin
The process of soldering stainless steel with tin difficult, so before starting work it is necessary to consider the question whether the alternative connection details, for example, screws or adhesive compositions.
The key issues is the proper selection of electric soldering iron and flux. The soldering iron has the following requirements:
- Sufficient capacity — at least 100 watts in order to warm up the soldering zone was enough;
- The ability to adjust power;
- The possibility of self-cleaning sting from the residue of burnt flux, etc.
For soldering stainless steel is the perfect solder is pure tin, as this metal does not contain toxic lead, which can adversely affect the ability of the use of the product for food purposes.
In order to exclude the oxide film, the surface of stainless steel before brazing should be treated with a flux. For stainless steel is more suitable for phosphoric acid.
It can more rapidly heat the stainless steel surface before soldering. If power soldering iron is not enough, use the gas burner.
The company Electrocentury-steel offers to buy at affordable prices from the manufacturer tin designed for high-quality soldering stainless steel. Supplier arranges timely delivery of products to any place specified by the consumer.
The technological process of soldering stainless steel with tin
Optimal parameters are:
- The preheat temperature, 0 C — 230…250;
- The contact time of the solder with the metal surface, is not more than 10;
- The diameter of the tin wire, mm 2…4.
Form the supply of solder bar or wire does not matter, however when soldering the large tunnel better and easier to use wire. Stainless steel surface is thoroughly cleaned from surface contamination. It is better to use hard metallic brush. After cleaning, the surface is degreased, and only then it is possible to apply the flux (with the exception of combined compositions, in which the flux and solder contained in the source material — the paste).
To control the temperature of the soldering iron is used control the color of the flame on the tip: normal color — bright blue, in which the molten solder will be the most uniform.
To buy at an affordable price tin soldering of stainless steel products the company offers Electrocentury-steel. Supplier guaranteed prompt delivery of products to any destination specified by the customer.