Tin the soldering iron
Buy tin, which is necessary for high-quality iron soldering, offers the company Elektrovek-steel. Available prices are from the manufacturer. The supplier ensures the timely delivery of products to the address specified by the consumer.
Practical application of soldering iron with tin
In industry, the technology is used:
- In workshops of car-care center for body works, where with its help thin-walled parts are fastened to a thin steel sheet;
- In the form of tinning, when the application of a layer of tin on the surface ensures its protection from corrosion processes;
- For sealing of threaded connections;
- For the purpose of eliminating or reducing the porosity of surfaces;
- To ensure a more tight fit of the bearings.
In all these cases, the so-called low-temperature soldering of iron by tin is used, since all solders containing tin melt at temperatures below 450 ° C. Such soldering is considered to be simple in execution, and does not require high qualification of the worker. All solders that contain tin have high heat and electrical conductivity, as well as sufficient mechanical strength indicators with respect to the finished compound of iron products.
The company Elektrovek-steel offers to purchase at an affordable price tin solders, providing a good quality of soldering iron. The supplier ensures timely delivery of products to any point specified by the consumer.
Sequence of soldering
For soldering, except for tin solders (iron is used most often solder brand POC 40), it is also necessary to flux. The purpose of fluxes is to protect the soldering zone from oxygenation of the air. For soldering iron, zinc chloride, rosin, ammonia, and a number of special pastes are used.
Before soldering, the products are thoroughly cleaned of impurities, fatty films and oxides. Then the soldering iron is heated (if its design presupposes regulation of the heating temperature, then a temperature of at least 400 ° C is set for iron soldering). The joints are covered with flux, and by moving the soldering iron after the solder, they make a connection. The finished seam is rinsed and cleaned with a soft dry cloth after soldering.
If the configuration of the junction of iron parts is complicated, soldering is performed before soldering, and in this form it is possible to completely fill the seam. Flux residues are removed after soldering.
Buy at a bargain price, consumables required for high-quality soldering iron with tin, offers the company Electrovek-steel. The supplier guarantees the timely delivery of the products to any point specified by the customer.