Table - calculate the weight of sheet, strip, copper strips. The sizes and thicknesses of sheet, strip, ribbon copper
The company Electrocentury-steel offers a variety of assortment of sheet metal of copper. Works best price from manufacturers. Vendor provided prompt delivery of a strip, sheet or tape of any thickness and width to the address set by the user.
The calculated method
Is used when the ordered copper sheet, strip or tape have a non-standard size, which will affect the result obtained using the traditional online-calculator. Copper sheet weight is determined from:
M = PV where ρ is the density of copper, V is the volume of the sheet (lengthxwidthxthickness) mm3.
The density of copper depends on the grade of metal. All kinds of technical copper (M1, M2, M3) according to GOST 859−2001 have the same value of this parameter: ρ = 8940 kg/m3. Welding copper grade MSR1 GOST 16130−90 a little easier — for her to ρ = 8900 kg/m3.
Knowing the parameters of the copper sheet, its weight to determine very simple.
However, set thus the weight per m of continuous rolling of copper is impossible, since the material comes in rolls or coils.
To buy a sheet of rolled copper strip, sheet, tape — at producer prices, the company offers Electrocentury-steel. The supplier shall ensure strict compliance with supply range, provides efficient transportation of products to the point specified by the customer.
Strips and strips of copper containing no oxygen, are made in accordance with the requirements of GOST 15471−77. The bands are available in the thickness range of 15…55 mm at width 350, 400, 450, 500 and 550 mm, and the tape is 2 to 12 mm and a width of from 40 to 300 mm. standard Length of the tape is:
- At a thickness of from 0.05 to 0.5 mm — not less than 20 m;
- When the thickness from 0.55 to 1,0 mm — not less than 10 m;
- At a thickness of from 1.10 to 2.50 mm — not less than 7 m.
The figure for copper strip is:
- For widths up to 300 mm (hot rolling) — 0,5…2,0 m;
- With a width of 350 to 450 mm (hot rolling) or 0.35…1.20 m;
- With a width of from 40 to 300 mm (cold rolling) — 0,5…2,0 m.
Next, you can use either method outlined above, or to estimate the mass limit on the mass of the Bay, which should not exceed 80 kg.
The company Electrocentury-steel offers affordable sheets and strips, of copper. The supplier guarantees compliance with the assortment of supplies, ensures timely delivery of rental to the consumer.