Technical characteristics

This is one of the most technologically advanced metals: it can be pressed, bent, drilled, cut and rolled easily. But in its pure form it is quite fragile, that is why magnesium alloys are more valuable as a construction material. Today they are the basis of the most modern construction materials in transport engineering.

Cutting and drilling

Cutting and drilling of magnesium is very complicated due to the use of cooling water in the cutting equipment, which accidentally gets on the heated magnesium and can cause the chips to ignite. In these cases, it is advisable to use equipment in which water cooling is replaced by gas cooling.

Feed rate

Large feed rates should be used. Small feeds contribute to twisted chips that can get stuck in the drill grooves. When drilling deep, it is recommended to use drill bits with a large helix angle.

Coolant

New oil-based metal cutting coolants and emulsols Ukrinol-1 and Akvol-2 have been created. They are prepared on petroleum oils of different viscosity with the introduction of various additives. The most important indicators of commercial coolants are viscosity, the content of mechanical impurities and the corrosive effect on the metal. These indicators for some coolants are given below

Supplier

We offer to buy magnesium and magnesium alloys from specialized warehouses of the supplier Evek GmbH with delivery in any city. Full compliance with modern quality standards. The supplier Evek GmbH offers to buy magnesium and magnesium alloys, the price is optimal in this segment of rolled metal products.

Buy, bargain price

Supplier Evek GmbH offers non-ferrous metals, price - determined by the technological features of production without including additional costs. We have the best price-quality ratio for the whole range of products.