Sheet, ribbon, wire 38hs - 37hs.

International Equivalent

Mark Analogue W. Nr. Aisi Uns En Order
38XS Delivery from the stock, in stock

Evek GmbH offers to buy sheets, strips, wires made of 38KhS and 37hs structural alloy steels at a favorable price from the manufacturer. The supplier guarantees strict compliance with the range of supply of rolled products, provides delivery of products to the location specified by the customer.

Chemical composition

Steel 38HS, refers to a group of steels, additionally alloyed with silicon and chromium. It is produced by metallurgical companies of CIS countries in accordance with technical standards of GOST 4543. The composition of the steel is given below:

Component C Si Mn Cr Cu Ni
Content in steel, % 0,34...0,42 1,0...1,4 0,30...0,60 1,30...1.60 Maximum 0.30 Not more than 0.30.

The standard allows up to 0.15% of molybdenum in 38Cr steel. The percentage of non-metallic impurities (sulfur and phosphorus) must not exceed 0.035%.

The closest analogue of this steel in Europe is 37hs steel, which is produced by the Polish steel industry in accordance with the requirements of national standard PN-H-84030. Steel grade 37hs differs from steel 38HS lack of molybdenum.

The company Evek GmbH offers to buy sheets - sheets, strips and wires made of chromium and silicon alloyed steel 38HS and 37hs at producer price. The supplier guarantees adherence to the product range and timely delivery of products to the address specified by the customer.

Properties and application

Forging of 38ХС and 37хS steel grades are used for production of small mechanical gears parts: rings, washers, cams, clutch housings, etc., as well as high-strength fasteners under dynamic loads and bending stresses. The steel is prone to manifestation of temper embrittlement and is characterized by the reduced ability to weld (requires preliminary annealing), so it is not recommended for the manufacture of welded structures.

Mechanical parameters of 38KhS and 37hs steels after quenching and tempering operations:

  • Tensile strength - 780...950 MPa;
  • yield strength - 630...750 MPa;
  • Relative elongation - 15...16%;
  • Relative reduction of cross-sectional area - 45...50%;
  • Brinell hardness - not more than 255 НВ;
  • Impact toughness - 650...700 kJ/m2.

Company Evek GmbH offers to buy sheets, strips and wires made of 38ХС and 37hs alloyed constructional steels at economically advantageous price from the manufacturer. The supplier guarantees strict adherence to the product range, timely transportation of products to the consumer is ensured.