|Designation GOST Cyrillic||30Х3МФСА|
|Designation GOST Latin||30X3MFCA|
|By chemical elements||30Cr3MoVС|
30Х3МФСА steel is used: for the production of hot-rolled calibrated steel used for the manufacture of parts for shipbuilding, special and military equipment in the heat-treated and nitride state.
Structural steel high-quality chrome-molybdenum-vanadium. Steel heat resistant up to 500 °C.
|Test methods. Packing. Marking||В09||ADU8-TU|
According to ADU8-TU, the chemical composition is given for steel grade 30X3MFSA. In the steel grade 30X3MFSA-SH, the mass fraction of sulfur is not more than 0.015%, phosphorus - no more than 0.025%, copper - no more than 0.25%. The presence in the steels of 30X3MFSA and 30X3MFSA-III grades of residual titanium mass fraction up to 0.030% and tungsten up to 0.20% is not a defective feature. Permissible deviations from the norms of chemical composition in accordance with GOST 4543.
|Section, mm||sT|s0,2, MPa||σU, MPa||d||y, %||KCU, kJ/m2||HB, MPa|
|Calibrated hot-rolled steel as supplied for АДУ8-TU. Quenching in oil from 950±15 °C + Vacation at 660-680 °C, air cooling (graph toughness given a value KCV)|
Description mechanical marks
|sT|s0,2||Yield strength or limit of proportionality with a tolerance for residual deformation of 0.2%|
|σU||Limit short-term strength|
|d||Elongation after rupture|
|y||The relative narrowing|
|HB||Brinell hardness number|
|Macrostructure and pollution||Steel control on the contamination of non-metallic inclusions (FROM,OS,SH,SP,SN,S). For steel ESR allowable non-metallic inclusions not greater than 3 points for all types of inclusions. For ordinary steel smelting - the rules optional , but shall be recorded in the certificate. Grain size-steel is not larger than the number 5 on a scale of I GOST 5639.|
|Features of heat treatment||In accordance with an order of hot-rolled steel АДУ8 THAT put in the heat-treated and without heat treatment, and calibrated in the released condition. Brinell hardness number hot rolled, heat treated steel should not exceed 269 HB (indentation diameter not less than 3.7 mm).|